Position; No Signal Power Off; Power Save Mode - Panasonic TH-86CQ1U Operating Instructions Manual

Position

Adjusts the position.
[Position] - submenu screen
Note
●
In some cases, noise appears outside the area
picture is displayed, but it is not a malfunction.
●
It is only available for PC input.
Picture Audio
Language
Network settings
Parental control
Closed caption
HDMI-CEC control
EDID select
Position

No signal power off

Power save mode

Move Select
ENTER
Picture Audio
Auto setup
H-position
V-position
Dot clock
Clock phase
Reset
Move Select
ENTER
■
[Auto setup]
Sets the operational mode of the automatic position
adjustment.
Note
●
[Auto setup] may not work when a cropped or dark
image is input. In such case, switch to a bright
image with borders and other objects are clearly
shown, and then try [Auto setup] again.
■
[H-position]
Adjusts the horizontal position of the image.
■
[V-position]
Adjusts the vertical position of the image.
■
[Dot clock]
Periodic striped pattern interference (noise) may
occur when a striped pattern is displayed. If this
happens, adjust so that any such noise is minimized.
Setup
Return Exit
MENU EXIT
Setup
Return Exit
MENU EXIT
■
[Clock phase]
Adjusts sampling clock for applicable video.
Useful when small characters appear with low
contrast and/or there are flickers at corners.
When using the adjustment pattern, make
adjustments so that no horizontal stripe noise
appears in it.
●
It should be made only after [Dot clock] has been
correctly set.
■
[Reset]
Resets the values of [Position] items to the factory
default settings.
Note
●
In some cases, noise appears outside the area
picture is displayed, but it is not a malfunction.
●
It is only available for PC input.
● In the case that [Auto setup] cannot work well, [Auto
setup] may work well to execute [Reset] before [Auto
setup].
No signal power off
When this function is set to [Enable], the power is turned
off (standby) automatically when there is no signal of the
TV for 10 minutes.
Starting from 1 minute- before the turn off, the
remaining time will be displayed.
No signal 33 Sec.
Power save mode
■
[Off]
It is reduced that startup time from standby mode.
However, more power will be consumed in standby
mode.
■
[On]
The TV᾿s consumption in standby mode is reduced.
However, the startup time from standby mode
becomes longer.
Note
● If set to [On] , certain serial commands and LAN
control cannot be used in standby mode.
41
English