Siemens IFP1900 INOX PRO Compact Operating Instructions page 8

Product description
Service pack 3, in connection with devices for support arm mounting
Service pack 3 contains:
● 1 spare seal for the connection compartment cover of the device
● 1 spare seal for the mechanical interface of the device
● 1 spare seal for support arm mounting
● 8 screws M5 x 20 mm for support arm mounting
● 6 screws for the connection compartment cover of the device
● 1 connecting terminal for the power supply
● 1 terminal block for the terminal strip in the connection compartment
● Documentation
Article number 6AV7675-1JD20-1AA0
Service manual
A service manual that describes the following maintenance work is available for the IFP1900
INOX PRO:
● Replacing the seal of the rear panel
● Replacing defective operator controls in the device front
● Converting a device for stand mounting into a device for support arm mounting and vice
versa
Opening the device and working on the opened device may only be carried out by qualified
and correspondingly trained personnel
The service manual describes, amongst other points, the opening of the device and
working on the wiring or on electronic components in the inside of the device. Injuries or
material damage may result if the work is not carried out correctly.
The work described in the service manual may only be carried out by qualified specialist
personnel who have been trained correspondingly by Siemens.
The service manual is available online under "Product Support" next to this document in the
same branch of the product tree.
8
WARNING
Compact Operating Instructions, 07/2019, A5E35751632-AC
IFP1900 INOX PRO