Bosch ICP-SOL2-P Quick Reference Manual page 18

Control Panel
6 Communication Fail
A communication fail registers when the control panel fails to communicate with the receiving
party (such as a monitoring company, mobile phone). The communication fault clears once the
control panel successfully reports to the receiving party.
A communication fail also registers when network module is disconnected or tampered.
To determine which receiver or module failed to communicate, press and hold the [6] key.
7 Output and Codepad Fail
The output fault registers when the output expander B308 is disconnected or tampered.
The codepad fault registers when any codepad is tampered or disconnected from the control
panel.
To determine which fault occurred, press and hold the [7] key.
8 Keyfob Low Battery
This fault occurs when any of the RF keyfobs report a low battery condition to the control
panel. To determine which keyfob failed, press and hold the [8] key. Only keyfob 1 to 16 faults
display on the codepad through zone indicator 1 to 16.
Bosch Security Systems, Inc. Quick Reference Guide
Operating Commands | en
2014.06 | 02 | F01U298027
18