Table of Contents
Advertisement
6.8
Building Technologies
Fire Safety & Security Products
Enabling dynamic routing
Configuring the relay output
Configuring the relay output
The relay output can be activate by cable disconnection on Ethernet ports and by
other NK8237 failures, such as low memory, logging failures and software errors.
To enable the relay output for diagnostic purpose, proceed as follows:
1. Select the NK8237 node and expand the subtree.
2. In the toolbar on the left, select the Onboard I/O icon
A new Onboard I/O node appears.
3. Select the new I/O Onboard node.
4. In the toolbar on the left, select the Relay Output icon
A new Relay Output node appears under the Onboard I/O node.
5. Select the Relay Output node.
6. In the Supervision section of the Node tab, select the Enable supervision check
box.
Configuring the relay output for diagnostic purpose
Configuration
Configuring the relay output
.
.
A6V10403182_a_en
6
41
30.09.2014
Advertisement
Table of Contents
