Advertisement
Figure 8
Bottom view
1. Motor
2. Woodruff key
3. Square-head screw (4)
3. Align the slot in the shaft coupler with the Woodruff
key, and slip the shaft coupler onto the shaft of the
hydraulic motor
(Figure
4. Align the slot in the open end of the shaft coupler with
the Woodruff key in the sprayer pump shaft
Note: Ensure that there is a Woodruff key in the key
slot of the sprayer pump shaft
5. Position the coupler evenly over the motor and pump
shafts
(Figure
8).
6. Apply medium-duty, thread-locking compound on the
4 square-head screws, and secure the shaft coupler to
both shafts with the screws
4. Pump shaft
5. Shaft of the hydraulic
motor
6. Shaft coupler
8).
(Figure
(Figure
8).
(Figure
8).
4
Installing the Hydraulic Hoses
from the Hydraulic Motor to
the High-Flow Hydraulic Ports
No Parts Required
Procedure
1. Connect the free end of the hydraulic hose
(hydraulic-motor port-B) that you marked with tape
in step
2
of
the Hydraulic Motor (page 3)
quick-connect coupler panel
8).
1. Quick-connect coupler
(port-T—coupler panel)
2. Quick-connect coupler
(port-P—coupler panel)
2. Connect the free end of the other hose (hydraulic-motor
port A) to the to port-P of the quick-connect coupler
panel
(Figure
3. At the 2 straight fittings in the hydraulic motor, torque
the swivel nuts of the 90-degree fittings on the 2
hydraulic hoses
ft-lb).
5
Assembling the Fittings and Hoses to
to the to port-T of the
(Figure
9).
Figure 9
3. Hydraulic hose
(hydraulic-motor port-A)
4. Hydraulic hose
(hydraulic-motor
port-B—marked with
tape)
9).
(Figure
5) to 50 to 64 N∙m (37 to 47
Advertisement
