Advertisement
6
Installing the Rocker Switch
Parts needed for this procedure:
1
Rocker switch
1
Kit wire-harness adapter
Procedure
Note: Ensure that the control console and the electrical
harness are installed; refer to the Installation Instructions for
the sprayer.
1. Connect the 3-pin connector of the wire-harness
adapter to the 3-socket connector labeled
LOOP CONTROL KIT
(Figure
16).
Figure 16
1. Wire-harness adapter
2. Connect the rocker switch into the 8-socket connector
of the wire-harness adapter.
3. Install the rocker switch into the opening in the control
console
(Figure
17) until the switch snaps into place.
CLOSED
for the console-wire harness
2. 3-socket connector
(labeled
CLOSED
LOOP CONTROL
—console-wire
KIT
harness)
1. Rocker switch
9
Figure 17
2. Control console
Advertisement
