Toro 04238 Installation Instructions Manual page 4

Using one of the configurations shown in
Figure 8, adjust and secure the hitch straps to the
trailer tongue.
Low hitch position
High hitch position
Figure 7
Figure 7
Figure 8
Mounting the Greensmower
or
Wheel Assemblies
(Models 04244 and 04247 only)
Note:
On the Greensmaster 1000, 1010, and 2000
when equipped with a groomer, you must remove the
wheel shaft on the groomer end and purchase and
install a new wheel shaft (Part No. 106–5385). Also,
you must mount the rail assembly on the groomer
end to Greensmaster 1600 and 1610 hole locations
(Figure 2).
Note:
On the Greensmaster 1800, 1820, 2100,
g014667
and 2120 when equipped with a groomer, you
must remove the wheel shaft on the groomer end
and purchase and install a new wheel shaft (Part
No.136–7287).
1. Remove the existing standard transport wheels
from the wheel shafts on the Greensmower (if
equipped).
2. On the Greensmaster Flex 18 or 21 only,
proceed as follows:
A. Remove the right side drum cover from the
machine
g014668
1. Right side drum drive
cover
2. Felt seal
B. Remove and discard the rubber grommet
from the axle hole in the drum cover
9).
C. Affix the felt seal to the inside of the cover
positioning it around the axle hole
9).
D. Install the cover to the machine.
4
(Figure 9).
Figure 9
3. Rubber grommet
g017122
(Figure
(Figure