Table of Contents
Advertisement
3.
Insert a wheel onto each shaft and secure with a
wheel clip
(Figure
Note:
The Flex 1800, 1820, and 2100, 2120
series requires a different wheel offset than all
other Toro Greensmowers. Read and follow the
mounting instructions molded into the sides of
the wheels.
Figure 10
Left side shown
1. Wheel shaft
2. Wheel
10).
3. Wheel clip
Loading the Trailer
1.
While maintaining control of the trailer bed and
holding onto the handle, press down on the latch
assembly and the lift handle
the trailer bed to the ground.
g014669
1. Latch assembly
2.
On flat ramps, pivot the wheel rods upward
(Figure
13) and on rail ramps, rotate the wheel
rods parallel (open) to the ramp
3.
Remove the basket from the greens mower,
disengage the reel drive and move the throttle
to the slowest position. Slowly drive the greens
mower onto the trailer until the wheel stops are
contacted
4.
If the rail wheels are not centered on the rails,
loosen the fasteners securing the rails to the
trailer and adjust the rail position so the rail
wheels are centered, then tighten the fasteners.
5.
Shut off the engine and engage the parking
brake.
6.
Engage the wheel rods as follows:
5
(Figure
Figure 11
2. Handle
(Figure
(Figure
12).
11). Lower
g014670
14).
Advertisement
Table of Contents
