Commissioning - Siemens SIMATIC Ident Function Manual

Commissioning

1st step: Install communications module in STEP 7
To install the communications modules in STEP 7, follow the steps below depending on the
communications modules you are using:
● RF170C, ASM 475
● PROFIBUS ASM 456
● PROFINET RF180C
NOTICE
The "S7-compatible" setting results in addressing errors!
To operate the ASM 456 using the GSD file, the DP interface of the DP master must be set
to "DP-V1".
2nd step: Configure hardware in STEP 7
To configure the hardware in STEP 7, follow the steps below depending on the
communications module and the configuration you are using:
● ASM 475: Centralized configuration in S7-300
● ASM 475: Distributed configuration with PROFIBUS and ET 200M
● RF170C: distributed configuration via PROFIBUS or PROFINET and ET 200pro
● ASM 456: Distributed configuration with PROFIBUS
● RF180C: Distributed configuration with PROFIBUS
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618
The installation program for RF170C and ASM 475 must be run once on the STEP 7 PC.
The GSD file must be added to the device catalog using HW Config ("Options" > "Install
new GSD..."):
– Siem8114.GSD for ASM456
The GSDML file must be added to the device catalog using HW Config ("Options" >
"Install new GSD..."):
– GSDML-V2.2-SIEMENS-RF180C-20100329.xml
4
41