Siemens SIMATIC Ident Function Manual page 91

Parameter setting by means of GSD file
In addition to the control parameters relevant for PROFIBUS, several control parameters
relevant for RFID are also defined for the ASM 456 in the GSD file. The parameters relevant
for RFID are set using the "Object properties" of the slave in HW Config. The following table
shows the possible settings:
Table A- 11
USER_Mode
MOBY_Mode
Baud rate reader
Diagnostics with diagnostic
messages (see Section
"Error messages and
troubleshooting" )
Not permitted with MOBY D with SLG D11S/D12S
1)
Input parameters for ASM 456
Assignment is made in UDT 10.
You will find the list of the input parameters for ASM 456 in the section "Parameter data
block (Page 19)".
Table of commands for ASM 456
Assignment is made in the UDT 20 by means of the "command" variable.
You will find a list and description of the commands in the section "Command parameters
(Page 30)".
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618
Setting of MOBY-relevant parameters
Parameter name
FB 45 / FC 45
FB 55 / FC 55
FB 56 / FC 56
RFID standard profile
MOBY I, E normal addressing
MOBY I filehandler
MOBY U, D / RF300 standard
addressing
MOBY U filehandler
RF300 Filehandler
19.2 kBd
57.6 kBd
115.2 kBd
None
Hard errors
Hard/soft errors low priority
Hard/soft errors high priority
Brief description of the hardware
Value
Default
-
-
dependent on the firmware
version
Default
only with FC 56
(also applies to RF200)
only with FC 56 (multitag)
-
MOBY U/D / RF200 / RF300
MOBY U/D / RF200 / RF300
MOBY U/D / RF200 / RF300
Standard diagnostics only
Hardware-related messages only
All messages
All messages high-priority
A.3 ASM 456
Note
1)
1)
91