14
MW 800 Vehicle Installation Guide
MW 800 Display
The MW 800 display is attached to the display mount by Phillips screws (M4), supplied in
the display shipping carton. The Display Signal Cable is routed from the CPU box, through
the mount, and connected to the lower back side of the display. Use caution when assembling
the cable to the display, to prevent damage to the display or the cable. Form a service loop for
the Power and Display Signal Cables to reduce cable tension. Use plastic cable ties to secure
the cables to cable tie points.
Allow Service
Loop
Figure 10
Display Cable Route
Long Display Signal Cables (longer than 3 Meter, 9.14 foot) should be routed
!
inside protective ducts to avoid damage
Caution
The MW800 Display is shipped with a protective film that covers the
!
touch screen.
Once installation is completed, the protective film must be removed to
Caution
avoid damage to the touch screen during operation.
Power Cable
USB Keyboard Cable
Display Signal Cable