Motorola MW 800 Series Vehicle Installation Manual page 32

26 MW 800 Vehicle Installation Guide
Table 3
AUX Connection - Model F5206
Table 4
AUX Connection - Model F5207
Pin No. Signal
14 MONITOR_MODE
15 +5V
Pin No. Signal
1 USB-AUXPOS
2 USB-AUXNEG
3 VBUS-AUX
4 GND
5 LINE-OUT-R
6 LINE-OUT-L
7 SPDIF
8 IGNITION
9 BOOTBLOCK#
10 PROG-ENTER-
AUX
11 GND
12 MICNEG
13 VREF-MIC
14 V12-OUT
15 V12-OUT
16 GPI0
Description
Service input signal
Output power. Maximum 2 Amps. Output is
automatically disconnected when CPU box
temperature is above operating range
Description
USB I/O Positive
USB I/O Negative
USB Output
Ground
Right Speaker Output
Left Speaker Output
Digital Audio I/O
12V DC Ignition sense input from ignition key
Crisis BIOS boot-up input signal (active low
signal). Used to boot the CPU box from an
external drive that connects to any of the USB
ports.
Enable input signal for the "one wire"
programming of the HC08 controller in the
CPU box
Ground
Microphone negative output signal
Microphone positive output signal
Output power. Maximum 1 Amps. Output
inhibits when CPU box temperature is above
operating range. The output power
corresponds to the power that operates the
CPU box
Identical to pin 14
General purpose digital input number 0, TTL
level (5V)