Motorola MW 800 Series Vehicle Installation Manual page 52

46 MW 800 Vehicle Installation Guide
Protocol
RF Power Output
GPS
WLAN
Bluetooth
ENVIRONMENTAL
Operating
Temperature
Storage Temperature
Humidity
DURABILITY
Shock
Vibration
Drip
Dust Blowing
Salt Fog
iDEN (25 kHz spacing)
0.6 Watts (variable in 6 steps) into 50-Ohm load
F5206 - Internal Trimble™, SK II
F5207 - F5217 - Internal Trimble™, SQ
F5217 - Internal U-Blox with Dead Reckoning
F5206 - IEEE 802.11b, 11 Mbps
F5207 & F5217 - IEEE 802.11b/g, 11/54 Mbps
Version 1.1 compatible (in 12.1"display model) Supports
data and voice profiles
F5206: -22 to 158°F (–30 to +70°C) for the 1.7 GHz
processor
-22 to 122°F (–30 to +50°C) for all other processors
Notes:
• Performance at extremes include start-ups (with
occasional slight delay due to hard drive heater ramp-
up time) and sustained operations of typical mobile
workstation applications.
• UL certification is available only to 131°F (55°C),
though continued operations are available above this
limit.
• When using 9 VDC battery to power the workstation,
the workstation will not power up if the temperature
range is below -22°F (-30°C)
F5207 & F5217: -22 to 158°F (-30 to +70°C)
–40 to 158°F (–40 to +70°C)
90 to 95% Relative humidity at 50°C for 8 hours
20g peak 1/2 sine wave @ 11ms, 30 impacts
Per TIA/EIA 603 Paragraph 3.3.4 and MIL-STD-810F
method 514.5, Fig 514.5C-1
Per MIL-STD-810F method 506.4 Procedure III
Five hours in dust (140 mesh silica flour), laden
atmosphere dust agitation time is for 2 seconds every 15
minutes
8 hours, 5% Sodium Chloride at 35°C, after exposure,
per MIL-STD-810F 509.4, Procedure I