Operation; Reset; Dump Mode - Toshiba B-850 Owner's Manual

4. ON LINE MODE
4.2

Operation

4.3

Reset

NOTE:
If the [ RESTART] key is held
for less than 3 seconds when the
printer is in an error or pause
state, the printer restarts
printing. However, when a
communication error or
command error occurs, the
printer returns to an idle
condition.
4.4

Dump Mode

When the printer is turned on, the "ON LINE" message appears on the
LCD message display. It is shown during standby or normal printing.
1. The printer is turned on, standing by, or printing.
2. If any error occurs during printing, an error message appears. The
printer stops printing automatically. (The number on the right column
shows the number of unprinted media.)
3. To clear the error, press the [RESTART] key. The printer resumes
printing.
4. If the [PAUSE] key is pressed during printing, the printer stops
printing temporarily. (The number on the right column shows the
number of unprinted media.)
5. When the [RESTART] key is pressed, the printer resumes printing.
Reset operation clears the print data sent to the printer from the computer,
and returns the printer to an idle condition.
1. The printer is turned on, standing by, or printing.
2. To stop printing, or clear the data sent from the computer, press the
[PAUSE] key. The printer stops printing.
3. Press and hold the [RESTART] key for 3 seconds or longer.
4. Press the [PAUSE] key. The data sent from the computer will be
cleared, and the printer returns to an idle condition.
In Dump mode, any characters sent from the host computer will be
printed. Received characters are expressed in hexadecimal values. This
allows the user to verify programming commands and debug the
program.
And for other details, please refer to your nearest TOSHIBA TEC service
representative.
4- 2
EO1-33029
4.2 Operation