Toshiba B-850 Owner's Manual page 92

APPENDIX 4 SYSTEM MODE
A4.5 Test Print (Cont.)
NOTE:
Cut mode is available only when
the optional cutter module (B-
7208-QM) is installed. When
you need the cutter, please
contact your nearest TOSHIBA
TEC service representative.
NOTE:
Press and hold the [RESTART]
or [FEED] key to advance the
values quickly and continuously.
To stop it, release the key.
NOTE:
When "PAPER FEED" is
selected, the printer feeds the
media prior to a test print to
adjust the print start position.
When "PAPER NO FEED" is
selected, the printer starts
printing without a print start
position adjustment. If the
print start position adjustment
is unnecessary, Select "PAPER
NO FEED" and save media.
Issue Mode Selection
Select the issue mode for the test print by selecting between "[S]NO
CUT" (Batch mode without cut) and "[C]WITH CUT" (Cut mode).
[RESTART]
[FEED]
After selecting the Issue Mode, press the [PAUSE] key to go to Label
Length Setting.
Label Length Setting
Select the label length for the test print in a range from 5 mm to 999 mm.
[RESTART]
[FEED]
[FEED] key: Pressing the [FEED] key one time causes a –1 mm change,
up to 5 mm.
[RESTART]key: Pressing the [RESTART] key one time causes a +1
mm change, up to 999 mm.
After selecting the label length, press the [PAUSE] key to go to Paper
Feed Selection.
Paper Feed Selection
Select whether or not a paper feed is performed.
[RESTART]
[FEED]
After selecting the paper feed, press the [PAUSE] key. The display
returns to the "<4>TEST PRINT".
A4-16
EO1-33029
A4.5 Test Print
Batch mode
without cut
Cut mode
Paper feed is
available.
Paper feed is not
available .