Appendix 4 System Mode; A4.1 Operation Panel - Toshiba B-850 Owner's Manual

APPENDIX 4 SYSTEM MODE

APPENDIX 4 SYSTEM MODE
IMPORTANT !
If System Mode is needed for
any other purposes, please
contact a TOSHIBA TEC
authorized service
representative before
performing any operation in
System Mode.

A4.1 Operation Panel

NOTE:
Use the [RESTART] key to
resume printing after a pause
condition, or after clearing
an error.
Appendix 4 describes usage and purpose of the keys on the Operation
Panel in System Mode.
For end users, System Mode should be used for the following four
purposes:
To check and print the system status, the Maintenance Counter, and
the Print Head Element.
To make fine adjustment related to the media issue.
To perform a test print for checking print quality.
To set the parameters for the PCL Emulation.
The figure below illustrates the Operation Panel and key functions.
LCD Message Display
POWER LED
(Green)
[RESTART] key
[FEED] key
The LCD Message Display shows messages in alphanumeric characters
and symbols to indicate the printer's status. Up to 16 characters can be
displayed on one line.
There are three LEDs on the Operation Panel.
LED
POWER The printer is turned on.
ON LINE
The printer is ready to print.
ERROR
Any error occurs with the printer.
In System Mode, the [FEED], [RESTART] and [PAUSE] keys
function as described below.
Used to start the system mode as a [RESTART] key
FEED does. Used to select the parameter mode or to fine
adjust the parameters in the negative direction (-).
Used to select the parameter mode or to fine adjust
RESTART
the parameters in the positive direction (+).
Used to start the system mode as a [FEED] key does.
PAUSE
Used to select the parameter mode. Used as an enter
key.
A4- 1
POWER ONLINE ERROR
FEED RESTART PAUSE
Illuminates when...
EO1-33029
A4.1 Operation Panel
ERROR LED (Red)
ON LINE LED (Green)
[PAUSE] key