A1.3.2 Detection Area Of The Transmissive Sensor - Toshiba B-850 Owner's Manual

APPENDIX 1 SPECIFICATIONS
A1.3.1 Media Type (Cont.)
Item
c
Minimum media pitch
d
Label length
e
Width including backing paper
f
Gap length
g
Black mark length (Tag paper)
h
Effective print width
i
Print speed up/slow down area
j
Black mark length (Label)
Max. print length
Maximum effective length for on the fly issue
Max. outer roll diameter
Thickness
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified media.
2. When using the cutter ensure that label length
(i.e. label pitch should be greater than 38 mm.)
3. When requesting black marks on label rolls, the following requirements must be satisfied.
When the gap length is less than 4 mm:
The black mark length should be longer than the gap length.
When the gap length is 4 mm or more:
The black mark should not overlap the gap for more than 4 mm or the following label.
Black marks should be printed on reverse side of the gaps. Also, they should contact or overlap the
preceding label's bottom end line.
4. "On the fly issue" means that the printer can feed and print without stopping between labels.

A1.3.2 Detection Area of the Transmissive Sensor

The transmissive sensor is movable from the center to the left edge of media.
The transmissive sensor detects a gap between labels, as illustrated below.
(Min. 6.0 mm when using
the cutter module.)
Label dispensing mode
Label + backing paper
Tag
Area to be detected.
Sensor position
Min. 2.0 mm
Min. 12 mm
Batch mode
15.0
Min. 12.5
100.0- 242.0
2.5 – 20.0
2.0 – 20.0
d
plus inter-label gap length
Center of media
Label
Gap
Label
Sensor is movable
within this range.
A1- 3
Cut mode
Label: 38.0
Tag: 25.4
Min. 32.0
100.0 – 235.0
6.0 – 20.0
2.0 – 10.0
216.8 0.2
1.0
6.0 – 20.0
640.0
320.0
230
0.13 – 0.18
0.08 – 0.18
f
exceeds 38 mm.
Print side
Media feed direction
EO1-33029
A1.3 Media
[Unit: mm]