Action For Tilt Bucket Sensor Offline; Action For Sensors Are Invalid; Other Error - Komatsu PC360LCi-11 Operation & Maintenance Manual

TROUBLES AND ACTIONS

ACTION FOR Tilt Bucket Sensor Offline

Phenomena: Communication with Tilt sensor for the tilt bucket
is not established.
Stop the operation and perform the following procedure.
1.
Check if the density of triangle mesh (TIN) of the design
data is high.
2
If it is 9/m or more, this message may be easily displayed.
2.
Check if the setting for the bucket is correct on the Bucket
Configuration.
For details, see "BUCKET CONFIGURATION".
If the setting is correct, tilt sensor or wiring harness has a trouble.
Check if the failure code is not displayed on machine monitor, and then ask your Komatsu distributor for an
investigation of the cause and repair of it.

ACTION FOR Sensors are invalid

Phenomena: Sensors (stroke sensing hydraulic cylinder, IMU
sensor, stroke and reset sensor for cylinder, EPC, etc.) of MC
are not connected or faulty.
Check if the density of triangle mesh (TIN) of the design data is
high.
2
If it is 9/m or more, this message may be easily displayed.
Sensors (stroke sensing hydraulic cylinder, IMU sensor, stroke and reset sensor for cylinder, EPC, etc.) of MC
may have a trouble.
Stop the operation. Check if the failure code is not displayed on machine monitor, and then ask your Komatsu
distributor for an investigation of the cause and repair of it.

OTHER ERROR

Message displayed on con-
trol box
No GPS localization...
Waiting for satellites...
3-76
Back- Semi-
ground auto
color mode
Not the number of control points in the
Red availa- control point file is not enough or the
ble setting is incorrect.
Red *1 Acquiring satellites
Main causes
OPERATION
Remedy
Check the setting of the
control point files.
Move the machine to the
place where no obstacles
exist.
Check the connection of
connector.