Toro Z Master 8000 Series Setup Instructions page 5

1. Front caster
2. Rear-deck rollers
Note:
Ensure that the discharge tube does not
catch on the crate when driving the machine off
the crate (Figure
WARNING
Operating the mower without the locking
pins securely latched can result in the
mower deck folding up unexpectedly.
The mower deck folding up unexpectedly
can cause serious injury.
Always operate the mower with the
locking pins securely latched.
19. Drive the machine off the crate.
Removing the Machine from the
Crate Using a Hoist
CAUTION
The mower deck is shipped in the Up
position, but not latched. Removing shipping
reinforcements without supporting the front
of the deck causes the deck to drop, which
may result in injury or property damage.
Always securely support the front of the deck
while setting up the machine.
Figure 8
3. Plywood between the
drive wheels
4. Wood ramp for the front
casters
4).
1. Remove the rear caster-wheel assembly from
inside the hopper.
2. Remove the bolt holding the rear frame to the
crate (Figure
3. Lift the front of the hopper up.
Note:
Use care when hoisting the machine to
prevent damaging the hopper.
4. Using the hoist, lift the machine at the location
shown in
g026151
1. With the hopper up, lift the machine on each side here
CAUTION
Raising the mower deck for service
or maintenance relying solely on
mechanical or hydraulic jacks could be
dangerous. The mechanical or hydraulic
jacks may not be enough support or may
malfunction allowing the machine to fall,
which could cause injury.
Do not rely solely on mechanical
or hydraulic jacks for support. Use
adequate jack stands or equivalent
support.
5. Raise the rear of the machine approximately
25.4 to 30.5 cm (10 to 12 inches) and support it
with jack stands or equivalent support
10).
5
11).
Figure 9.
Figure 9
g026283
(Figure