Toro Z Master 8000 Series Setup Instructions page 7

Figure 13
1. Deck-support pin
2. Strut between the
deck-support pins
21. With the deck-locking pins pulled out in the
unlock position, carefully lower the deck
14).
Figure 14
1. Deck-lift handle
2. Rotate the deck-locking
pin toward the rear and
pull outward to unlock.
22. Push the deck-locking pins inward and rotate
them forward to securely lock the deck in the
lowered position.
g025171
3. Side-strut hardware
(Figure
g006790
3. Push the deck-locking pin
in and rotate toward the
front to lock.
3
Installing the ROPS
International Machines Only
Parts needed for this procedure:
1 ROPS Kit (sold separately)
Procedure
Install the ROPS Kit as described in the Installation
Instructions for the kit.
4
Installing the PTO-Shaft
Guards
International Machines Only
Parts needed for this procedure:
1 Long guard
1 Guard
4 Bolt (1/4 x 1 inch)
4 Flat washer (1/4 inch)
4 Retainer nut (1/4 inch)
Procedure
Note:
This procedure is only for international
machines.
Note:
The guards are located in the hopper of the
machine.
Note:
The guards are shipped assembled together
with the parts listed above. Ensure the guards are
installed after lowering the mower deck.
1. Shut off the engine, wait for all moving parts
to stop, and remove key. Engage the parking
brake.
2. Lower the mower deck.
3. Loosen the bolts attached to the rubber guard
(Figure 15).
7