Connecting The Lighting Wire Harness; Extending The Axle - Toro MMX-650E-S 60212C Operator's Manual

Note: Crossing the chains decreases the chances of
the front of the machine dropping to the ground if the
hitch does not hold the connection.
1
Figure 20
1. Connecting links
2. Keyholes in front post
3. Connect each length of chain to the safety chain
mounting point on the tow vehicle with the connecting
links (Figure 21).
1
2
3
Figure 21
1. Connecting link
2. Safety chain mounting
point on tow vehicle
Connecting the Lighting Wire
Harness
Connect the electrical plug of the machine with the electrical
plug of the tow vehicle, as shown in
2
3
G021 177
3. Chain crossed under tow
pole
G021 178
3. Chain link
(Figure 22).
Note: The machine uses a standard 4-flat plug. If your tow
vehicle has a different type of plug, obtain an adapter from an
automotive parts store.
Important: Routinely check the lights to ensure that
they are working properly, including the tail lights, brake
lights, and each appropriate turn signal.

Extending the Axle

WARNING
The machine is not stable when towing it with the
axle in the narrow position.
Tow the machine with the axle in the wide position.
Important: Adjust the axle to the narrow position only
to move the machine through a narrow access point,
such as the gate of a fence or the doorway of a building.
Preparing to Change the Axle Width
1. Move the machine to a level job-site surface.
2. Disconnect the machine from the tow vehicle.
3. Chock the tires.
4. Ensure that the drum is empty and in the mix position
(upright).
5. Ensure that the drum latch is engaged and that the
drum does not rotate toward the dump position.
Adjusting the Axle Width
WARNING
Mechanical or hydraulic jacks may fail to support
the machine and cause serious injury.
Use jack stands when supporting the machine.
1. Align a jack with an adequate lift height and weight
capacity under the axle; refer to
11).
2. Lift the machine until the tires are off the ground.
3. Use a jack stand at each support point on the rear
frame extension
15
G020828
Figure 22
Specifications (page
(Figure 23).