Toro MMX-650E-S 60212C Operator's Manual page 2

WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
Use of this product may cause exposure to
chemicals known to the State of California
to cause cancer, birth defects, or other
reproductive harm.
Introduction
This machine is designed to mix mortar, plaster, fireproofing
material, grout, and other small-grained cement products. A
vehicle equipped with an appropriate pintle hitch or ball hitch
can tow the machine..
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
safety and operation training materials, accessory information,
help finding a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready. Write the numbers in the space provided.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
1. Model and serial number
location
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
The DOT tire information is located on the side of each tire.
This information gives load and speed ratings. Replacement
tires should have the same or better ratings.
Note: The various machines in this manual have different
weights; refer to Specifications (page 11)
tires on your machine meet or exceed the weight requirements
of your machine.
2
Figure 1
2. Vehicle identification
number (VIN) location
(Figure
Figure 2
to ensure that the
Contact us at www.Toro.com.
Printed in the USA
All Rights Reserved
2),