SUN2000-(2KTL-5KTL)-L1
User Manual
Procedure
Step 1 Assemble the positive and negative connectors by referring to
Power
Cables with high rigidity, such as armored cables, are not recommended as battery cables,
because poor contact may be caused by the bending of the cables.
Step 2 Insert the positive and negative connectors into corresponding battery terminals on the
SUN2000.
After the positive and negative connectors snap into place, pull the battery cables back to
ensure that they are connected securely.
Issue 01 (2020-04-17)
During the installation of the SUN2000 and battery, the positive or negative terminal of
the battery will be short-circuited to ground if power cables are not installed or routed as
required. In this case, an AC or DC short circuit may occur and damage the SUN2000. The
caused device damage is not covered under any warranty or service agreement.
The cabling distance between the battery and the SUN2000 should be less than or equal to
10 meters, and within 5 meters is recommended.
Cables.
The battery voltage will result in serious injury. Use dedicated insulation tools to connect
cables.
Ensure that cables are correctly connected between the battery terminal and the battery
switch, and between the battery switch and the SUN2000 battery terminal.
Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connection
5.6 Connecting DC Input
49