Silvercrest SEM 1100 A1 Operating Instructions Manual page 77

Generating hot water
1) When the appliance is heated-up:
2) Place a cup under the milk frother
3) When the green heating-up control lamp
knob 2 to the position "+".
4) Turn the rotary switch
zle.
5) If you wish to interrupt the hot water supply, turn the steam control knob
off (as far as it will go in the direction "-") and place the rotary switch 5 at
the position "
6) Switch the appliance off with the on/off switch
Cleaning and Care
WARNING - RISK OF INJURY!
■ Always remove the plug from the mains power socket before you clean the
appliance. Risk of electric shock!
■ Always allow the appliance to cool down before you start to clean it. Risk of
Burns!
■ NEVER submerse the appliance in water or other liquids. Risk of electric
shock!
Cleaning the milk frother
ATTENTION - PROPERTY DAMAGE
■ NEVER use abrasive, corrosive or chemical agents to clean the appliance.
These could damage the upper surfaces of the appliance.
1) Place an empty container under the milk frother
2) Immediately after use turn the steam control knob
for a few seconds, allow the steam to escape.
3) Turn the steam control knob
switch the appliance off and remove the plug from the mains power socket.
4) Allow the nozzle to cool down.
5) Remove the nozzle and clean it thoroughly in warm water.
6) Check to see if the small hole in the nozzle is clogged and, if so, clear it with
a needle.
Espresso Machine
z.
5 to the position "
".
2 off (as far as it will go in the direction "-"),
4 glows, turn the steam control
". Hot water fl ows from the noz-
3.
z.
2 to the position "+ " and,
2
GB
MT
75