Table of Contents
Advertisement
Chapter 2
Installing the Device
1.
Review the relevant certification information for any regulatory requirements. For more information, refer to
Section 7.1,
"Approvals".
2.
Mount the device.
3.
Connect the failsafe alarm relay.
4.
Connect power to the device and ground the device to safety Earth.
5.
Connect the device to the network.
6.
Configure the device.
Section 2.2
Unpacking the Device
When unpacking the device, do the following:
1.
Inspect the package for damage before opening it.
2.
Visually inspect each item in the package for any physical damage.
3.
Verify all items are included.
IMPORTANT!
If any item is missing or damaged, contact Siemens for assistance.
Section 2.3
Mounting the Device
The RUGGEDCOM RS969 is designed to be mounted on a panel by affixing the top and bottom flanges of the
device to a panel using screws.
IMPORTANT!
Heat generated by the device is channeled outwards from the enclosure. As such, it is recommended
that 2.5 cm (1 in) of space be maintained on all open sides of the device to allow for some
convectional airflow.
Forced airflow is not required. However, any increase in airflow will result in a reduction of ambient
temperature and improve the long-term reliability of all equipment mounted in the rack space.
NOTE
For detailed dimensions of the device with panel mount hardware installed, refer to
"Dimension
To mount the device to a panel, do the following:
1.
Place the device against the panel and align the flanges with the mounting holes.
10
Drawings".
RUGGEDCOM RS969
Installation Guide
Section 5.7,
Unpacking the Device
Advertisement
Table of Contents
