Bosch Condens 7000 F Installation And Maintenance Instructions For The Contractor page 65

Inspection work
12. Recording measurements:
• Discharge pressure
• Gross flue gas temperature t
• Air temperature t
L
• Net flue gas temperature t
• Carbon dioxide content (CO
or oxygen content (O
• CO content, air free
13. Carry out function checks:
• Check ionisation current.
• Test the differential pressure switch.
14. Check for leaks during operation.
15. If necessary, check function of installed water
treatment cartridge and check for wear.
16. Check that the control unit is set correctly in line with
demand (see documents for the control unit).
17. Final check of servicing work
Confirm correct inspection
Company stamp/date/signature
Table 25 Inspection and maintenance record
If any condition requiring maintenance is identified in the course of the
inspection, this work must be carried out as required.
The requirements for replacement of gaskets are detailed in
Chapter 11.11.3, page 42.
Condens 7000 F – 6720871560 (2019/11)
Page
29
A
- t
A L
)
2
)
2
29
54
30
–
–
Full Load Partial load
________Pa ________Pa
________ °C ________ °C
________ °C ________ °C
________ °C ________ °C
_________% _________%
_______ppm _______ppm
________μA ________μA
Appendix
Full Load Partial load
________Pa ________Pa
________ °C ________ °C
________ °C ________ °C
________ °C ________ °C
_________% _________%
_______ppm _____ppm
_______μA ______μA
65