Infocenter Display - Toro e-Dingo 500 Operator's Manual

Loader-Arm Lever
•
To lower the loader arms, slowly push the
loader-arm lever forward.
•
To raise the loader arms, slowly pull the loader-arm
lever rearward.
Auxiliary-Hydraulics Lever
•
To operate a hydraulic attachment in the forward
direction, slowly pull the auxiliary-hydraulics lever
out and then pull down.
•
To operate a hydraulic attachment in the reverse
direction, slowly pull the auxiliary-hydraulics lever
out and then push it upward. This is also called
the D position because it does not require
ETENT
operator presence.
Parking-Brake Lever
•
To engage the parking brake, rotate the lever
down (Figure 5).
•
To release the parking brake, rotate the lever up
(Figure 5).
1. Parking-brake
lever—engaged
Eco-Mode Switch
Press the switch to the O
Mode. Use Eco Mode to reduce the motor speed and
reduce battery consumption.
Figure 5
2. Parking-brake
lever—disengaged
position to activate Eco
N
Inch-Mode Switch
Press the switch to the O
Mode. Use Inch Mode to slow the speed of the
machine when installing or removing attachments,
making small adjustments with the machine, and
turning corners.
Note:
Inch Mode overrides any current settings (e.g.,
Eco mode, attachment modes). The machine will
return to those settings when Inch Mode is off.

InfoCenter Display

The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics and other information about the machine
(Figure 6). There is a splash screen and main
information screen of the InfoCenter. You can switch
between the splash screen and main information
screen at any time by pressing any of the InfoCenter
buttons and then selecting the appropriate directional
arrow.
1. Indicator light
2. Right button
•
Left Button, Menu Access/Back Button—press this
button to access the InfoCenter menus. You can
g303557
use it to exit any menu that you are currently using.
•
Middle Button—use this button to scroll down
menus.
•
Right Button—use this button to open a menu
where a right arrow indicates additional content.
Note:
The purpose of each button may change
depending on what is required at the time. Each
button is labeled with an icon displaying its current
function.
Figure 7 shows what you may see on the InfoCenter
when you run the machine. The splash screen
displays for a few seconds after you turn the key to
the O position then the run screen displays.
N
10
position to activate Inch
N
Figure 6
3. Middle button
4. Left button
g264015