Toro e-Dingo 500 Operator's Manual page 26

Figure 24
1. Charger-output connector
8. Observe the charger to ensure that the batteries
are charging.
Note:
The battery-charging indicator light
should flash and the charging-output indicator
light should illuminate.
The machine amperage, displayed on the
InfoCenter, increases while the batteries charge.
If the amperage remains at 0, the batteries are
not charging.
9. Disconnect the charger when the machine
reaches a sufficient level; refer to
the Charging Process (page
10. Pivot the charger cover in place and slide it
down over the lower bolt
g306958
2. Machine charger
connector
Completing
26).
(Figure 23).
Monitoring the Charging Process
and Troubleshooting
Note:
The LCD status display displays messages
during the course of charging. Most are routine.
If there is a fault, the error indicator light will flash
amber or a solid, light red. An error message will
appear in the InfoCenter 1 digit at a time, starting with
the letter E or F (e.g., E-0-1-1).
To correct an error, refer to
If none of these solutions correct the issue, contact an
Authorized Service Dealer.
Completing the Charging Process
When charging is complete, the battery-charging
indicator light (Figure
the machine InfoCenter displays 10 solid bars.
Disconnect the charger connector from the machine
connector.
26
Troubleshooting (page
22) shows solid green and
37).