Table of Contents
Advertisement
Electrical System
Maintenance
Electrical System Safety
•
Disconnect the main-power connectors before
repairing the machine.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.
Disconnecting or
Connecting Power to
the Machine
The main-power connectors provide power from
the batteries to the machine. Disconnect the power
by separating the connectors; connect the power
by installing the connectors together. Refer to
Disconnecting the Main Power (page
Replacing the Static Strap
Service Interval: Before each use or daily—Check
the static strap; replace it if worn or
missing.
1.
Park the machine on a level surface, lower the
loader arms, and engage the parking brake.
2.
Shut off the machine and remove the key.
3.
Under the platform, replace the static strap as
shown in
Figure
Figure 32
1. Nut
2. Static strap
29).
32.
3. Washer
4. Bolt
Servicing the Batteries
Note:
The machine is equipped with 7 lithium-ion
batteries.
If you attempt to open the main compartment of
a battery, you will void your warranty. If a battery
requires service, contact your Authorized Service
Dealer for assistance.
Dispose of or recycle lithium-ion batteries in
accordance with local and federal regulations.
Maintaining the Battery
Charger
Important:
All electrical repairs should be
performed by an Authorized Service Dealer only.
The operator can perform very little maintenance other
than protecting the charger from damage and weather.
Maintaining the Battery-Charger
Cords
•
Clean the cords with a slightly damp cloth after
each use.
•
Coil the cords when not in use.
•
Periodically examine the cords for damage, and
replace them when necessary with Toro-approved
parts.
Cleaning the Battery-Charger Case
Clean the case with a slightly damp cloth after each
use.
g315429
31
Hide quick links:
Advertisement
Table of Contents
