Huawei ECC500 User Manual page 85

ECC500
User Manual
Figure 5-23 Adding an ATS
Table 5-10 ATS parameters
Parameter
Communication
Board Slot
Communication
Board COM
Equipment Address
Timeout
Step 4 Click Add Equipment.
----End
Follow-up Procedure
If the device addition fails, check whether the settings are consistent with the device
parameters.
Issue 05 (2020-03-16)
Setting
Select 3 from the drop-down list box.
NOTE
The setting example indicates that the ATS is connected to the COM5 port
of the RS485 card in slot 3 of the ECC500. If the ATS is connected to
another port, set the slot number for the connected port.
Select 5 from the drop-down list box.
NOTE
The setting example indicates that the ATS is connected to the COM5 port
of the RS485 card in slot 3 of the ECC500. If the ATS is connected to
another port, set the number of the connected port.
In this example, set Equipment Address to 1. Set the actual
device address of the ATS during operations.
The default timeout interval is 2s. Set the parameter to the required
value.
Copyright © Huawei Technologies Co., Ltd.
5 UI Description
77