Table of Contents
Advertisement
6.19.12.5.1
Disabling the Sensor Temporarily
Procedure:
1 Short-press the preprogrammed Sensor button or the preprogrammed Menu Select button to
activate the sensor timer.
The following scenarios affect the sensor state:
•
If a gun or taser is removed from the holster within the timer duration, the timer stops and
switches the sensor to disabled state. A tone sounds and the radio displays Sensor
Disable.
NOTICE: The radio enables the sensor only when all the guns or tasers are placed
into the holster. A tone sounds and the radio displays Sensor On temporarily.
•
If the timer expires without an event, a tone sounds, the radio switches the sensor to enabled
state, and clears the sensor status from the display.
•
If the preprogrammed Sensor button or the preprogrammed Menu Select button is long-
pressed, the over-the-air (OTA) sensor notification is enabled.
6.19.12.5.2
Disabling the Sensor Permanently
Procedure:
1 Long-press the preprogrammed Sensor button or the preprogrammed Menu Select button to
permanently disable the sensors.
A tone sounds and the radio displays Sensor Off. While in this state, no events is reported
over-the-air (OTA), regardless of how many times the gun is drawn, re-inserted or weapon is
fired.
The radio generates a bad key tone if the sensor is not allowed to be disabled or there is no
sensor connected to the radio when the preprogrammed button or menu select button is
pressed.
2 Long-press the preprogrammed Sensor button or the preprogrammed Menu Select button
again to enable the OTA Sensor notification.
A tone sounds, and the radio displays Sensor On.
6.20
ASTRO 25 (P25) Programming Over Project 25 (POP25)
Also called Over-the-Air Programming, this feature allows configuration data and firmware to be
upgraded to your radio over-the-air. Full use of the radio is retained during the data transfer without
interrupting communication.
If the upgrade happens on the ASTRO 25 and ASTRO Conventional systems, the upgrade pauses to
give priorities to voice call, and continues after the voice call ended. If the upgrade happens on a Wi-Fi
network, the upgrade process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio, you can install new changes immediately or
delay changes to be installed on the radio when it is being powered up.
MN004476A01-AE
Chapter 6: Advanced Features
109
Advertisement
Table of Contents
