Husqvarna Automower 105 Operator's Manual page 17

To make an island on page
stake. Refer to
17 .
• Make an eyelet (F) where the guide wire is
to be connected to the boundary wire.
3.4.3.1 To put the boundary wire in a slope
The product can operate in 25% slopes. Slopes
that are too steep must be isolated with the
boundary wire. The gradient (%) is calculated as
height per m. Example: 10 cm / 100 cm = 10%.
10%
100 cm/40"
10 cm/4"
• For slopes steeper than 25% inside the work
area, isolate the slope with boundary wire.
• For slopes steeper than 15% along the outer
edge of the lawn, put the boundary wire 20
cm / 8 in. (A) from the edge.
>15%
A
• For slopes adjacent to a public road, put an
obstacle of minimum 15 cm / 6 in. along the
outer edge of the slope. You can use a wall
or a fence as an obstacle.
3.4.3.2 Passages
A passage is a section that has boundary wire on
each side and that connects 2 parts of the work
area. The distance between the boundary wire on
each side in the passage must be a minimum of
60 cm / 24 in.
Note: If a passage is less than 2 m / 6.5 ft. wide,
install a guide wire through the passage.
The minimum distance between the guide wire
and the boundary wire is 30 cm / 12 in. The
product always runs to the left of the guide wire
1285 - 004 - 16.04.2020
as seen facing the charging station. It is
recommended to have as much free area as
possible to the left of the guide wire (A).
A
>60 cm / 24"
>30 cm / 12"
3.4.3.3 To make an island
CAUTION: Do not put a section of
boundary wire across the other. The
sections of boundary wire must be
parallel.
CAUTION: Do not put the guide wire
across the boundary wire.
CAUTION: Isolate or remove obstacles
that are less than 15 cm / 5.9 in. in
height. Isolate or remove obstacles
that slope slightly, for example, stones,
trees or roots. This will prevent
damage to the blades of the product.
>2 m / 6.5 ft
Installation - 17