Husqvarna Automower 105 Operator's Manual page 26

OK .
4. Push
5. Enter the new PIN code again.
OK .
6. Push
7. Make a note of the new PIN code. Refer to
Introduction on page 3 .
3.10.5.2 To set the security level
Select 1 of 3 security levels for your product.
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the multi-choice buttons to move
through the menu structure
Security level .
3. Use the multi-choice buttons to select the
level of security.
OK .
4. Push
3.10.5.3 To create a New loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if two
adjacent installations have a very similar signal.
1. Place the product in the charging station.
To get access to the menu
2. Do steps 1–3 in
on page 23 .
3. Use the multi-choice buttons to move
through the menu structure
loop signal .
OK and await confirmation that the
4. Push
loop signal has been generated. This
normally takes about 10 seconds.
3.10.6 Settings
In settings you can change the general settings
to your product.
3.10.6.1 ECO mode
ECO mode stops the signal in the boundary loop,
the guide wire and the charging station, when the
product is parked or is charging.
ECO mode to save energy and avoid
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
26 - Installation
Note: Push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
To set the ECO mode
1.
2.
3.
Security >
3.10.6.2 To set the Time & Date
1.
2.
3.
4.
5.
6.
3.10.6.3 To set the language
Security > New
1.
2.
3.
3.10.6.4 To set the country
1.
2.
3.
3.10.6.5 To reset all user settings
1.
To get access to the menu
Do steps 1–3 in
on page 23 .
Use the multi-choice buttons to move
through the menu structure
mode .
OK .
Push
To get access to the menu
Do steps 1–3 in
on page 23 .
Use the multi-choice buttons to move
through the menu structure
& Date .
Use the number buttons to set the time and
OK .
then push
Use the number buttons to set the date and
OK .
then push
Use the multi-choice buttons to set the time
OK .
format and then push
Use the multi-choice buttons to set the date
format and then push OK .
To get access to the menu
Do steps 1–3 in
on page 23 .
Use the multi-choice buttons to move
through the menu structure
Language.
Use the multi-choice buttons to select
OK .
language and then push
Do steps 1–3 in To get access to the menu
on page 23 .
Use the multi-choice buttons to move
through the menu structure
Country.
Use the multi-choice buttons to select
OK .
country and then push
To get access to the menu
Do steps 1–3 in
on page 23 .
1285 - 004 - 16.04.2020
Settings > ECO
Settings > Time
Settings >
Settings >