Husqvarna Automower 105 Operator's Manual page 18

To make an island, isolate areas in the work area
with the boundary wire. We recommend to isolate
all stable objects in the work area.
Some obstacles are resistant to a collision, for
example, trees or bushes that are more than 15
cm / 5.9 in. in height. The product will collide with
the obstacle and then select a new direction.
• Put the boundary wire to and around the
obstacle to make an island.
• Put the 2 sections of boundary wire to and
from the island close together. This will
make the product run across the wire.
• Put the 2 sections of boundary wire in the
same stake.
0 cm / 0"
3.4.3.4 To make a secondary area
Make a secondary area (B) if the work area has 2
areas that are not connected with a passage. The
work area with the charging station is the main
area (A).
Note: The product must be manually moved
between the main area and the secondary area.
18 - Installation
B
A
• Put the boundary wire around the secondary
area (B) to make an island. Refer to
make an island on page 17 .
Note: The boundary wire must be put as 1
loop around all of the work area (A + B).
Note: When the product cuts grass in the
secondary area, the
Operating modes on page
selected. Refer to
28 .
3.4.4 To examine where to put the guide
wire
• Put the guide wire in a line at a minimum of
2 m / 7 ft. in front of the charging station.
• Make as much free area as possible to the
left of the guide wire when facing the
charging station. Refer to
page 24 .
• Put the guide wire minimum 30 cm / 12 in.
from the boundary wire.
• Do not make sharp bends when you install
the guide wire.
135º
135º
• If the work area has a slope, put the guide
wire diagonally across the slope.
To
MAN mode must be
Guide width on
90º
1285 - 004 - 16.04.2020