Symbols On The Product; Symbols On The Display - Husqvarna Automower 105 Operator's Manual

22. Extra blades
23. Operator's Manual and Quick Guide
24. Measurement gauge for help when installing
the boundary wire (the measurement gauge
is broken loose from the box)
1
25. Power supply
26. Low voltage cable
27. Alarm decal
28. Cable markers
29. Rating plate (incl. product identification
code)

1.4 Symbols on the product

These symbols can be found on the product.
Study them carefully.
WARNING: Read the
user instructions before
operating the product.
WARNING: Disable the
product before working on
or lifting the product.
WARNING: Keep a safe
distance from the product
when operating. Keep
your hands and feet away
from the rotating blades.
WARNING: Do not ride
on the product. Never put
your hands or feet close
to or under the product.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
Use a detachable power
supply as defined on the
rating label next to the
symbol.
This product conforms to the
applicable EC Directives.
1
The appearance may differ depending on market
1285 - 004 - 16.04.2020
Noise emission to surroundings. The
product's emissions are set out in
Technical data on page 46 and on the
rating plate.
It is not permitted to dispose this
product as normal household waste.
Ensure that the product is recycled in
accordance with local legal
requirements.
The chassis contains components
which are sensitive to electrostatic
discharge (ESD). The chassis must
also be resealed in a professional
manner. For these reasons the chassis
shall only be opened by authorized
service technicians. A broken seal can
result in the entire or parts of the
guarantee no longer being valid.
The low voltage cable must not be
shortened, extended or spliced.
Do not use a trimmer nearby the low
voltage cable. Be careful when
trimming edges where the cables are
placed.

1.5 Symbols on the display

Timer menu you can set when
In the
the product will cut the lawn.
Security menu you can select
In the
between 3 security levels.
In the Installation menu you can set
manual settings for the installation of
the product.
Settings menu you can set the
In the
general product settings.
Introduction - 5