To Do The Product Settings - Husqvarna Automower 105 Operator's Manual

3. Push the arrow buttons and the OK button.
Select language, country, date, time and set
a PIN code.
Note: For some models, a factory PIN code
is necessary before you select a personal
PIN code. It is not possible to use 0000 as
PIN code.
4. Push the Start button and close the hatch to
initiate a calibration process of the product.
Note: If the battery is too low, the product
needs to charge the batteries fully before the
calibration starts. Refer to
page 23 .
Note: Make a note of the PIN code. Refer to
Introduction on page 3 .
3.9.3 Calibration
The calibration process is automatic. After the
basic settings are done, the product moves away
from the charging station and stops, while it
calibrates some of the product settings. When the
calibration is complete, the product starts to mow.

3.10 To do the product settings

Use the control panel to set all settings for the
product. The control panel has a display and a
keypad, you can access all functions through the
menus. The functions have factory settings that is
applicable for almost all work areas, but the
settings can be adapted to the conditions for
each work area.
3.10.1 Menu structure
The main menu contains:
Timer
•
Installation
•
Security
•
Settings
•
Menu structure overview on page 7 .
Refer to
3.10.2 To get access to the menu
1. Push the STOP button.
2. Enter the PIN code on the keypad.
3. Push the multi-choice button.
1285 - 004 - 16.04.2020
3.10.3 To do the timer settings
Note: Set the
600 m
and wear on the product.
3.10.3.1 To set the timer
1.
Calibration on
2.
3.
4.
5.
6.
7.
8.
3.10.3.2 To calculate the timer setting
1.
2.
3.
Note: The operation capacity is approximate and
is calculated for flat and open work area. If the
work area has a lot of slopes or obstacles, you
need to increase the
Model
Automower
Example: A lawn of 500 m
Automower
Timer if the work area is less than
2
/ 0.15 acre to prevent wear on the lawn
To get access to the menu
Do steps 1–3 in
on page 23 .
Use the multi-choice buttons to move
through the menu structure to select
Use the multi-choice buttons to select
hours 1 or Work hours 2 .
Enter the time with the number buttons.
OK .
Push
Use the multi-choice buttons to select
days .
Use the multi-choice buttons to select the
days that the product will operate.
OK .
Push
Calculate the dimension of your lawn in m
2
ft .
2 2
Divide the m / ft of the lawn with the
approximate operation capacity. Refer to
table below.
The result is equal to the number of hours
that the product must operate each day. The
number of hours includes both mowing,
searching and charging time.
Timer settings.
Approximate operation ca-
2
pacity, m
®
105 43 / 463
2
/ 5400 ft
®
105.
Timer .
Work
Work
2
/
2
/h / ft /h
2
, cut with an
Installation - 23