Chapter 5 Startup; Startup Procedure Flow - Toshiba V Series Operation Manual

Integrated controller, control network fl-net opcn-2, module

Hide thumbs Also See for V Series:

Table of Contents

This chapter describes the FL312 module startup procedure.

6F8C1067

Chapter 5 Startup

START

Set node number with mode address

switch at bottom of module.

Install FL312 in prescribed I/O bus slot.

Connect MAU external power supply and

shielded ground wire of AUI cable to

terminal block.

Connect communication cable.

Turn on MAU power and then turn on the

controller power.

Set parameters with engineering tool.

Turn on the controller power once more.

Startup

Figure 5-1 Startup procedure

Then communication starts automatically

when the controller power is turned on

and RUN mode is entered.

Table of Contents

Show Quick Links

Table of Contents

3000 fa Fl311 Fl312