Toro 68130 Installation Instructions

Tow pole hitch for end-dump concrete mixers

Download this manual

Tow Pole Hitch

for End-Dump Concrete Mixers

Model No. 68130

Model No. 68131

Model No. 68132

WARNING

CALIFORNIA

Proposition 65 Warning

This product contains a chemical or chemicals

known to the State of California to cause cancer,

birth defects, or reproductive harm.

8111 Lyndale Avenue South

Bloomington, MN 55420

Safety

Safety and Instructional

Decals

Safety decals and instructions are easily

visible to the operator and are located near

any area of potential danger. Replace any

decal that is damaged or lost.

125–8216

1. Read the Operator's

Manual for information on

how to tow the machine.

Original Instructions (EN)

Printed in the USA

Form No. 3379-218 Rev A

Installation Instructions

2. Warning—limit towing

speed to less than 55 mph

/ 88 km/h.

Page 1 Form No. 3379-218 Rev A Tow Pole Hitch for End-Dump Concrete Mixers Model No. 68130 Model No. 68131 Model No. 68132 Installation Instructions Safety WARNING Safety and Instructional CALIFORNIA Proposition 65 Warning Decals This product contains a chemical or chemicals...
Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Tow pole Front stabilizer leg (shipped with the machine) Install the tow pole. Short bolt Long bolt Locknut Hitch assembly Flange-head bolt Install the hitch assembly.
Page 3 Installing the Hitch Assembly Parts needed for this procedure: Hitch assembly Flange-head bolt Locknut G023350 Procedure Figure 3 1. Using 2 flange-head bolts and 2 locknuts, loosely install the hitch assembly in the middle position of the 5. Align the top rear hole in the front stabilizer leg (Figure mounting plate.
Page 4 G023353 Figure 6 G023355 Figure 7 Ball hitch shown 1. Keyhole 3. Safety chain 1. Top position 3. Bottom position 2. Rod or wire (not included) 4. Connecting link 2. Middle position 2. Attach the safety chain to the length of rod or wire 4.

6813168132