Steps
1. Align the solid-state drive with the socket on the system board and slide it in.
2. Replace the screw (M2x3) that secures the solid-state drive to the system board.
3. Route the SATA cables through the cable management tab.
4. Secure the metal bracket to the chassis by installing the two (6x32) screws.
Next steps
1. Install the
2.5 in. hard drive
2. Install the
front
bezel.
3. Install the
side
cover.
4. Follow the procedure in
assembly.
after working inside your
computer.
Field service information
31