Scenario Description - Huawei RTN510 Configuration Manual

Safe City RTN510/PowerCube 500 DCN Configuration Guide

Scenario Description

DCN configuration is important for Safe City video surveillance. After DCN configuration is completed, you can remotely manage the
PowerCube 500 and RTN510 through the NE IP address.
Scenario Applicable Version
Access to the third- PowerCube 500: all
party network with versions
no need for VLANs RTN510: all versions
PowerCube 500:
Access to the Layer V200R001C10SPC3
2 network through 00 or later
VLAN 4094 RTN510: all versions
Access to the third- PowerCube 500:
party network V200R001C10SPC3
through a VLAN ID 00 or later
other than 4094 RTN510: all versions
Direct access to the
third-party network
RTN510: all versions
by the AP/RT on the
aggregation node
HUAWEI TECHNOLOGIES CO., LTD.
1. The service port and NMS port of the PowerCube 500 on the aggregation node are
connected.
2. In an RTN510 AP/RT network, management packets are tagged with VLAN 4094. When
data is transmitted to the third-party network, these packets are changed into non-VLAN-
tagged packets.
Third-party networks require Layer 2 isolation between sites. Packets tagged with VLAN 4094
are transmitted to a Layer 2 network through the PowerCube 500 on the aggregation node.
1. In an RTN510 AP/RT network, management packets are tagged with VLAN 4094.
2. On the port used by the PowerCube 500 on the aggregation node to connect to the third-
party network, VLAN 4094 is converted into the VLAN ID planned for the third-party
network.
The RTN510 AP/RT is used as the aggregation node to connect to the third-party network.
Huawei Confidential
Description
Page 2