Huawei TE30 Manual page 11

Videoconferencing > Videoconferencing Infrastructure >

If you have not configured the NMS server or if the attempt to obtain the NMS server settings
times out, you must manually set the H.323 and SIP parameters to display the conferencing
screen.
Parameter Description
NMS server IP address of the SMC 2.0.

IPv4
IPv6

Connection Mode for obtaining an IP address.
type


Local IP IP address and subnet mask of your
address TE30.
Subnet To enable the TE30 to automatically
mask obtain the NMS server settings from
the SMC 2.0, ensure that the IP
address of the TE30 is in the same
network segment as that of the SMC
2.0.
IPv4 settings for the TE30.Under
IPv4, you must set Connection
type, Local IP address, Subnet
mask, and Gateway address.
IPv6 settings for the TE30.
Static IP: Your network
administrator assigns an IP
address to your TE30. If you
select this option, you must also
set Local IP address, Subnet
mask, and Gateway address.
Dynamic IP: When a DHCP
server is available on the network,
your TE30 automatically obtains
an IP address using the Dynamic
Host Configuration Protocol
(DHCP).
SMC2.0.
Setting
Contact your local reseller or
operator.
If the network has no SMC 2.0
deployed, leave this field blank.
By default, IPv6 is not selected.
If you select IPv6, you must set
Connection type, Local IP
address, Subnet prefix length, and
Gateway address. The TE30 will
then use IPv4 or IPv6 to
communicate with another endpoint
based on the endpoint's support for
IPv6.
The default value is Static IP.
If you have set NMS server, select
Static IP for this parameter.
Contact your network
administrator.
If an IP address conflict occurs,
change this IP address to one in the
specified IP address range. For example, if
the IP address range is 192.168.1.1 through
192.168.1.100, and the current IP address
is 192.168.1.2, change the section in
11