Motorola ASTRO 25 GTR 8000 Manual page 236

MN003286A01-E
Chapter 9: GTR 8000 Base Radio FRU Procedures
k Set the Network Time Protocol (NTP) Server Settings. See
page 148.
26 From CSS, restore the Codeplug Archive from backup. Reload the configuration file onto the
new device, as follows:
a From the menu, select File → Open.
b Locate and open the previously saved configuration file for the base radio.
NOTICE: If you were not able to back up the base radio configuration from the
previous base radio, use the configuration from your system build book or use the
default base radio configuration file. Specific settings for the base radio must still be
configured. See the CSS Online Help for detailed configuration instructions. If the
base radio is part of a Power Efficiency Package, ensure that the base radio Tx
Power Out in the CSS is limited to 50 W.
c On the Properties window, click OK.
d When the Progress Monitor screen is complete, click OK.
e From the menu, select File → Write Configuration To Device. Click OK.
f On the Ethernet connection confirmation screen, click OK.
g On the Connection screen, enter the <IP Address> and click Connect.
h On the SNMPv3 PassPhrase Prompt dialog box, enter the User Information and
Passphrase Information. Click OK. If Authentication Services are not enabled on a device,
click OK when the dialog box appears.
i On the confirmation screen, click OK.
j When the Progress Monitor screen is complete, click OK.
The configuration from the file selected is loaded into the base radio. Communication with the
base radio is not available until the reset is complete.
27 Read the base radio, as follows:
a From the menu, select File → Read Configuration From Device.
b On the confirmation screen, click OK.
c When the Progress Monitor screen is complete, click OK.
28 Place the base radio into Normal Mode, as follows:
a From the menu, select Service → Mode Screen.
The Mode Screen appears.
b Click Change to Normal Mode.
c At the confirmation screen, click OK.
The base radio halts activity in the current mode and switches operation to the requested
mode.
29 On systems with MAC Port locking, disable the locking and then re-enable the locking with the
MAC address of the base radio. The device being replaced may be connected to an Ethernet
port on a switch which implements MAC Port locking (HP switch or site controller). If so, the
Ethernet switch port must be unlocked and relocked to the MAC address of the replacement
device. See the MAC Port Lockdown manual for instructions on how to disable and enable MAC
Port locking.
NOTICE: Following device restoration, if it was connected to an HP switch port, the HP
switch port may have been disabled due to an unexpected MAC address. If so, re-enable
the port on the HP switch.
236
NTP Server Settings in CSS on