Table of Contents
Advertisement
MN003286A01-E
Chapter 11: GTR 8000 Base Radio Disaster Recovery
Chapter 11
GTR 8000 Base Radio Disaster
Recovery
This chapter provides references and information that assist in the recovery of a GTR 8000 Base
Radio in the event of failure.
11.1
Recovering the GTR 8000 Base Radio
Perform the following procedure to recover the GTR 8000 Base Radio.
Process:
1 To replace, install, connect power, and cable the base radio, see
Hardware Installation on page
2 To replace the transceiver module, see
steps 1 through 17.
3 To replace other hardware devices within or on the chassis, see
Procedures on page
4 To perform basic device configuration and SWDL download, see
Module on page 231
11.2
Performing a Site Download With PSC 9600 Site Controllers
When and where to use:
NOTICE: The following procedure does not apply to a site with a GCP 8000 Site Controller. To
perform the download for a site with a GCP 8000 Site Controller, see
Software Download With GCP 8000 Site Controllers on page
Procedure:
1 Transfer and install the latest software, using Software Download Manager with SNMPv1
package to the site controller and base radios, as follows:
a Connect an Ethernet straight through cable between the Ethernet port on the service
computer/laptop and the Ethernet LAN switch. The laptop IP address must be set to an
address on the subnet of the local site, which varies depending on the site and zone
numbers. See
2 Open the CSS application.
3 From the menu, select Tools → Connection Configuration.
The Connection Screen appears.
4 Verify that Ethernet is selected in the Connection Type area.
5 Specify the IP address for the device in the Ethernet Settings area. Perform one of the following
actions:
276
94.
Replacing a Transceiver Module on page 231
222.
and follow steps 18 through 32.
Connecting Through an Ethernet Port Link on page
GTR 8000 Base Radio
and follow
GTR 8000 Base Radio FRU
Replacing a Transceiver
Performing a Site
278.
140.
Advertisement
Table of Contents
Troubleshooting
