Application Of The Uv-Gel - Silvercrest SNS 45 A2 Operating Instruction

Application of the UV-Gel

GB
MT
108
Using the brush e, take a small amount of UV Gel s and then wipe the
excess on one side of the brush e off on the edge the UV Gel pot.
Apply a thin coating of UV-Gel s onto the complete nail. Apply a little more
UV Gel s to the lower part of the nail, as hereby is how the off set between
the natural and the artifi cial nail is created. Furthermore, the transition from
natural to artifi cial nails is especially sensitive to pressure and knocks, thus
more UV Gel s must be applied here.
INFORMATION
When you are doing the application do not press too heavily on the brush e,
►
since the brush e could otherwise cause streaking.
Model the fi rst layer of the UV Gel s very carefully, as this determines the
►
future shape of the nail. Model the best possible natural nail shape.
Maintain a distance of about 1 mm from the cuticle during the application.
NOTICE
Should any UV Gel s inadvertantly come onto the cuticle or the nail bed,
►
remove it before the hardening, for example, with a cotton wool swab.
Repeat the above process for all nails.
e
o
NOTICE
Ensure that the nail is covered evenly with UV Gel s.
►
SNS 45 A2