Sony SIR-1000W Instruction Manual page 32

3-18
$£ Tape position display area
• This area displays the following tape position and time information (source data or
tape data).
ADDRESS : Displays the tape position from the (00H00M00S) of each recording
block in hour, minute and second. The ADDRESS is set automatically
to 00H00M00S when recording begins.
Note
The ADDRESS counts in step with real time at normal speed, and
slows down in proportion to the speed at 1/2 speed or slower.
In addition, when operating at 1/2 speed or slower, the lower digit for
indication of seconds blinks at a rate of once per second.
REMAIN
: Displays the amount of tape remaining in hour and minute according
to the tape speed.
S-TIME
: Displays the current recorder time (source time) in year/month/day
and in hour/minute/second.
T-TIME
: Displays the time recorded on the tape in year/month/day and in hour/
minute/second.
Correspondence between the transport mode and the source data or tape data is
shown in the table below:
Transport Mode
E-E, REC-PAUSE, REC,
and succeeding STOP
FWD and
succeeding STOP
• In the OFFSET mode, this area displays the input DC offset value for the channel to
be set.
Display
ADDRESS, REMAIN, and
Source data
S-TIME valves set in recorder
ADDRESS, REMAIN, and
Tape data
T-TIME valves recorded on tape
Remarks