Sony SIR-1000W Instruction Manual page 78

Connecting the AUX Digital Data
Recording AUX Digital Data Signals
Playback AUX Digital Data Signals
7-2
Use a BNC cable (sold separately) to connect the AUX-1 (DIGITAL) IN connector on the
rear panel and the signal source.
If necessary, use a BNC cable to connect monitoring equipment to the AUX-1 (DIGITAL)
OUT connector on the rear panel.
When AUX digital data is input (high and low occur repeatedly within a set interval), the
AUX-1 LED in the display lights indicating the input signal is being fed in the E-E, REC-
PAUSE or REC mode. If the LED does not light, check the cable connections.
Signal source
Monitor equipment
!
CAUTION
• Do not input simultaneously a signal with a different ground level than those of the
analog data signals.
• The input/output level is TTL.
When recording starts, the AUX digital data signal input to the AUX digital channel is
recorded on the tape simultaneously along the main data signals.
The AUX-1 LED above the LCD screen lights when the input signal is detected.
When playing back a tape on which an AUX digital data signal has been recorded, the
AUX digital data signal is output from the AUX-1 (DIGITAL) OUT connector on the rear
panel.
The AUX-1 LED above the LCD screen lights when the playback signal is detected.
EXT. CONT COM SYNC
IRIG ON / OFF
APD OFF / ON
(UP / DOWN)
REMOTE AUX-2 (IRIG-B) AUX-1 (DIGITAL) TRIG/REC
IN OUT IN OUT IN
OPTION SLOT 2
LSB DIGITAL
OUTPUT
D4 D3 D2 D1 8
VOLTAGE
8 7 6 5 4 3 2 1 AC FUSE
!
! SELECTOR
T4A
220V
% / dB RAL / HLD
MST / SLV 9.6 / 19.2
240V
TRG S/M
PTRG OFF/ON
STAND BY
DC IN AC IN
XLR 32F DC BREAKER
CANNON
OPTION SLOT 1
ANALOG
OUTPUT
7 6 5 4 3 2 1