Backing Up Site Data With A Pc Card; Pc Card Backup Error Messages - NEC DS2000 Hardware Manual

Backing Up Site Data

Backing Up Site Data with a PC Card

You can use PC Card P/N 85880 to back up and restore your site data.
To use the PC Card to back up site data (Figure 5-1):
1. Insert the PC Card into the CPU.
2. Be sure the CPU mode switch is set to RUN.
3. Enter the programming mode.
4. Dial 9906 + HOLD.
5. Dial Y + HOLD.
6. Enter a name for the database you want to save (up to 10 characters long).
7. When you are done entering the name, press HOLD.
8. The system assigns the name you entered in step 7 to the data base address you select below:
- Press VOL
- Skip this step to select the currently displayed data base.
9. Press HOLD.

PC Card Backup Error Messages

NO PCCARD
ERASE FAILED
SAVE FAILED
5-2 Section 5: Maintenance Options and SMDR
ICM + #*#* + 372000 + HOLD
You see: START?
To quit program 9906 instead, dial N + HOLD .
You see: 9906: DATABASE NAME
Refer to Figure 5-2 Entering Names on page 5-3 if you need help when entering names.
Skip this step if you want to save data in an address that already has a name assigned.
You see the name and date of the first database stored. If no data bases are stored, you see:
9906: DB00
(empty)
or VOL to scroll through the addresses.
In software versions 02.00.01 and higher, there are 16 data base addresses:
DB 00 to DB 15.
OR
Normally, you see
9906: SAVING . . . . . . . . .
The PC Card Active LED is on during backup.
If the address you choose already has data stored in it, you see: REPLACE DB nn Y/N.
- Press N + HOLD to back up to step 5.
- Press Y + HOLD to proceed.
You automatically exit programming when the upload completes.
PC Card Backup Error Messages
This error message: Means this:
The PC card is not installed. Install the PC
card and try again.
The system could not overwrite an existing
data base on the PC card. Repeat the proce-
dure. If you get the message again, try another
PC card.
The system could not save data to the PC card.
Repeat the procedure. If you get the message
again, try another PC card.
DS2000 Hardware Manual