Section 1: Installing The Cabinet; System Preparation And Configuration; Unpacking; Before Installing - NEC DS2000 Hardware Manual

System Preparation and Configuration
System Preparation and Configuration

Unpacking

Unpack the equipment and check it against your equipment lists. Inspect for physical damage. If you are not
sure about a component's function, review the Product Description Manual. Contact your Sales Representa-
tive if you have additional questions.
Have the appropriate tools for the job on hand, including: a test set, a punch down tool and a digital voltmeter.

Before Installing

Make sure you have a building plan showing the location of the common equipment, extensions, the telco
demarcation and earth ground. In addition, the installation site must meet the requirements outlined in the
Standard Practices Manual.

Site Requirements

The common equipment is contained in the wall-mounted Main Equipment Cabinet. Choose a central location
for the cabinet that allows enough space for the equipment — and provides enough room for you to comfortably
work. Figure 1-1 4 Slot Cabinet Installation Layout on page 1-4 and Figure 1-2 8 Slot Cabinet Installation
Layout on page 1-5 show you about how much space your system requires.
System Configuration
Default Configuration
The factory installed default configuration for your DS2000 system (with software version 02.02.00 and
higher) is:
Slot CN1 = 16DSTU PCB (extensions 300-315).
Slot CN2-CN8 = Undefined.
Slots CN5-CN8 are only available with the 8 slot cabinet.
After plugging in your PCBs and powering up the system, use Program 9902 - Slot Control to enable
the installed PCBs. See Using Program 9902 in DS2000 to Add or Delete PCBs in your Quick Setup
Guide for more.
DS2000 Hardware Manual
System Preparation and Configuration
Section 1: Installing
the Cabinet

Section 1: Installing the Cabinet

1
1-1