Power Supply Installation
The power supply provides the DC power sources required to operate the system.
To install a power supply (Figure 1-11) (Figure 1-12):
1.
Slide the power supply into the CN101 slot. See Figure 1-12 Installing the Power Supply below.
2.
Using a long-shaft phillips head screwdriver, tighten the two screws that secure the power supply.
An 8 slot cabinet may require up to 3 power supplies, using slots CN101, CN102 and CN103. Refer to
System Configuration on page 1-1 for more. Install the first supply in slot CN101. Install the second supply
in slot CN103. Install the third supply in slot CN102.
DS2000 Hardware Manual
Figure 1-11: Power Supply
Figure 1-12: Installing the Power Supply
Power Supply Installation
Section 1: Installing the Cabinet
1
1-11