Speed Zero Control Block (Spd 0 Logic) - GE AV-300i User Manual

The Motopotentiometer Block is shown in the figure below.
Mpot up src
Mpot down src
Mpot invers src
Mpot preset src
Moto pot src
Mpot up src
Mpot down src
Mpot invers src
Mpot preset src
Moto pot cfg
Mpot lower lim
Mpot upper lim
Mpot acc dlt spd
Mpot acc dlt tim
Mpot dec dlt spd
Mpot dec dlt tim
Mpot init cfg
Mpot preset cfg
Moto pot mon
Mpot cmd mon
Mpot output mon

1.8.6 Speed Zero Control Block (Spd 0 Logic)

The Function of the Speed 0 Block is active only in a Sensorless and Field oriented mode.
The Function generates the Speed 0 signal, Spd is zero, and the Reference 0 signal, Ref is zero.
In the configurations it is possible to set: with Spd 0 speed thr and Spd 0 spd delay the Speed 0 threshold and
delay; with Spd 0 ref thr and Spd 0 ref delay the threshold and the delay of the reference 0. Furthermore
with Spd 0 enable it is possible to enable the gain adaptive function with a Speed 0 value and with Spd 0 P gain
and Spd 0 I gain to adapt the Proportional and Integral gain to a Speed 0 value.
The gains become active when both conditions Spd is zero and Ref is zero are true. They are not active when
Ref is zero is false.
AV-300i Version 2 User's Guide
Mpot lower lim
UPK
MPOT
DOWNK
CRTL
Mpot upper lim
INVK
Mpot init cfg
Source of the up command, speed increase
Source of the down command, speed decrease
Source of the command inverting the output speed
Source of the preset command
Upper limit
Lower limit
Delta speed acceleration for the Motopot ramp
Delta time acceleration for the Motopot ramp
Delta speed deceleration for the Motopot ramp
Delta time deceleration for the Motopot ramp
Configuration of the Init command
Configuration of the Preset command
Command monitor
Block output monitor
—————— Function Description ——————
Mpot acc dlt spd
Mpot acc dlt tim
Mpot dec dlt spd
Mpot dec dlt tim
Mpot preset cfg
Mpot output mon
101
Ch.1